Introduction of LD-I elevator load detector



  Introduction of LD-I elevator load detector:
  ※ Appearance of LD-I elevator load detector:

※ Technical characteristics:
★ LD-I is easy to install or adjust easier to debug。DS11-3 sensor is installed under the car cabinet。
★ Based on HALL EFFECT。no actual contact to the car of elevator。Mcu control。Having menu
To set parameter。
★ Can set the volue of light load、full load and over load of elevator。
★ support analogue outputs: voltage signal (0-10V) or current signal (4-20mA)。


※ Technical index:
★ Rated input voltage: DC24V±15%。
★ Relay output: DC60V 0.3A。
★ Input: DC15-30V。
★ Distance from alnico to DS11-3 sensor is 15-45mm。Best effect distance is 20-35mm。
★ Outline size of DS11-3 sensor: Φ22×97 mm。 
★ Outline size of LD-I elevator load detector : 155×105×42 mm。







http://www.alpha-lift.com          E-mail:alift@163.com
Copyright © 2003-2011 alpha-lift.com! inc. all rights reserved.